HomeIndustrial SectorCoolexPlantETL LabDuct WorksServices SectorSupply Chain ManagementWarehousingShuwaikh Port ColdstoreShuwaikh Vegetable ColdstoreDhajeej WarehouseCold Room Sales and MaintenanceLogisticsFacility ManagementTrading AgenciesContracting SectorCommercial Project ExecutionHVAC ProjectsElectromechanical ProjectsTurnkey ProjectsResidential Project ExecutionAbout RICRIC at a glanceManagement & Corporate StructureStrategyVision and ValuesHistoryLogo HistoryFacts Throughout the YearsInvestor RelationsFinancialsShare InformationHSE PolicyPressJobs and CareersJoining UsOur CultureDiversityJob SearchContact RIC established the first plant in Sulaibiya to manufacture central A/C and mini-split units. This plant is the first in the region and the only manufacturer of full range A/C units, heat exchangers and coil/tubing in Kuwait and has a capacity to produce over 50 models of central A/C units. Being the only local manufacturing plant in Kuwait, we appreciate that it is important to understand Kuwait’s torrid environment and as a result we manufacture units thath are specifically designed to suit the local and wider regional climate.

Strict procedures and processes are also implemented to meet the international standards and we have been certified with ISO 9001 since 1997. Our product range has capacities ranging from: Concealed Ducted Split Units, ranging from 2 TR to 5 TR Ducted Split A/C Units, ranging from 2 TR to 25 TR Packaged A/C Units, ranging from 4 TR to 25 TR Air-Cooled Packaged Chillers, ranging from 45 TR to 420 TR Air-Handling Units, ranging from 1000 CFM to 50,000 CFM. All of our unit designs comply with domestic and international standards. With a high efficiency rate, the units manufactured at the RIC Kuwait plant can perform reliably at ambient temperatures of 125’F; which is more than most other brands offer.The HE Series make-up air units offer the most efficient method available to heat make-up air. Direct fired make-up air heaters may be considered to be 100% efficient because no heat is vented to the atmosphere. The theoretical 100% efficiency should be reduced to 92% due to water vapor being formed as a natural by-product of the combustion process.

Units are available with heating capacities up to 14,000 MBH and air capacities up to 100,000 CFM. Units are also available in variable capacity, dual capacity, air curtain, and / or heat recovery configurations. HE SeriesDirect Fired Heaters 1,300 to 100,000 CFM Up to 25:1 turndown Indoor and outdoor configurations High Efficiency Green Burn Burners Learn More about GB Typical Options ( * ) represents standards featureshire portable air conditioning units uk View Brochure Flash formatportable ac units for casement windows Request Access to our Complete Catalogac unit throws breaker Due to continuous product development, specifications, dimensions and capacities are subject to change without notice.

The RE Series mix air units offer the most efficient method available to heat mix air. Direct fired make up air heaters may be considered to be 100% efficient because no heat is vented to the atmosphere.Units are available with heating capacities up to 11,000 MBH and air capacities up to 100,000 CFM. Units are also available in variable capacity, dual capacity, air curtain, and/or heat recovery configurations. RE SeriesDirect Fired Heaters Variable Outdoor Air Volume 1,600 to 100,000 CFM Indoor / Outdoor / Horizontal / Vertical THIS CLASS OF PRODUCT NOT PRESENTLY APPROVED FOR USE IN CANADAApplication of this product requires written approval from the appropriate chief provincial gas inspector. Our fee schedule and tools are meant to assist you in estimating building fees. Actual building fees vary from project to project. Final project fees may include items we collect on behalf of other agencies (e.g. 12% of all fees collected are returned to the State).

Additionally, projects within the City of Canby use their adopted fee schedule. We will discuss specific fees with you when you submit your plans or application. Heating, Ventilating and Air Conditioning (HVAC) Manufactured Dwellings, Park Trailers, Cabanas 1- and 2-Family Structural Inspections outside normal business hours $85/hr + OT (min 4-hr charge) Inspections with no specific fee listed (min. ½ hour) Add'l plan review required by change, additions or revisions to approved plans $85/hr (min 1-hr charge) Residential Certificate of Occupancy (charged when permit is issued) Temporary Certificate of Occupancy (commercial) $85/hr (min. 2-hr charge) Certificate of Occupancy (commercial) 1 & 2-family mechanical min. permit fee & re-inspection fee For each supplemental permit Alteration of existing HVAC system Fire/smoke dampers/duct smoke detectors Install/replace/relocate heaters - suspended, wall or floor-mounted

Vent for appliance other than furnace Environmental exhaust & ventilation Exhaust fan with single duct (bath fans) Hoods: Type l/ll residential kitchen/hazmat hood fire suppression systems Exhaust system apart from heating and AC Fuel piping & distribution (up to 4 outlets) Fuel piping (more than 4 outlets, each add'l) HVAC Air Handling Unit Up to 100K BTU Absorption unit to 100k BTU Up to 3HP/100K BTU 0 – 4 outlets Each additional (4 or more outlets requires a schematic) Residential plan review (when applicable) 25% of permit fee ($85 min. + a fee based on valuation as listed below. Note fees are based on valuation minimum) $85 + $1.66 for each $100 of value over $5,000 $168 + $12.34for each $1,000 of value over $10,000 $1,279 + $8.47for each $1,000 of value over $100,000 25% of base HVAC fee Site installation/set up fee for manufactured dwelling, park trailer or cabana Earthquake-resistant bracing system installation (in addition to site described above)

Re-inspection (fee must be paid prior to next inspection) Actual cost of investigation $85/hr (min. 4 hrs OT rate) OR Mfg. Dwelling Standard publication (required when no installer is involved) Mobile home park construction & recreational park development Varies w/ number of spaces Electrical (includes a prescribed number of inspections; see electrical permit application for quantities.) (includes a prescribed number of inspections; see electrical permit application for quantities.) Electrical plan review required for new construction and alterations in the following locations per OAR 918-311-0040: Service or feeder beginning at 400 amps with available fault current greater than 10,000 amps at 150 volts or less to ground, or any system greater than 14,000 volts Installation of 150 KVA or larger separately derived system per Article 100 of the NEC Addition of a new motor load greater than 100 HP Fire pump installations as defined in Article 695 of the NEC

Emergency systems installations as defined in Article 700 of the NEC Six or more residential units in one structure or any A, E, 1-2 or 1-3 occupancies as defined in the Oregon Structural Specialty Code 25% of permit fee Service or feeder rated at 60 amps or over System over 600 supply volts nominal Building more than 3 stories in height Building over 10,000 sq. ft. Occupant load over 99 persons Manufactured structures park or recreational vehicle park; new addition or alterations Classified area or structure containing special occupancy as described in NEC Chapter 5 Residential single-or multi-family dwelling units including attached garages and covered areas not more than 1,000 sq. ft. Each additional 500 sq. ft. Limited energy: up to two inspections only Manufactured home service or feeder Less than 200 amps Branch Circuits--new, alteration, extension per panel With purchase service or feeder Without purchase service or feeder:

• Each additional circuit 5 kva or less (2) 5.01 to 15 kva (2) 15.01 to 25 kva (2) Signal circuit/limited energy panel, alteration or extension Minimum permit fee and re-inspection fee Master permit fee (aka electrical in-plant inspections) Fire & life safety plan review 65% of building permit fee In conjunction with regular plan review 35% of building permit fee 40% of building permit fee $85 + $7.40/$1,000 over $2,000 to $25,000 $255.20 + $6.72/$1,000 over $25,000 to $50,000 $423.20 + $4.48/$1,000 over $50,001 $647.20 + $3.75 for each additional $1,000 1- & 2-Family Structural: New Construction, Additions, Remodels, Alterations $423.20 + $4.48/$1,000 over $100,000 $647.20+$3.75 for each $1,000 $70/hour (1 hr minimum) Payments, State e-permits, and refunds Building Permit Process for Residential One- and Two-Family Dwellings and Accessory Structures Building Permit Responsibility by Jurisdiction