Why is there water leaking out of the air-conditioner? The drainage could have been blocked due to some dirt being accumulated in the drainage pipe. OR, the aircon could be dirty. OR, there is insufficient refrigerant. OR, poor gradient of the drainage pipe or too long of a drainage pipe was installed in a restricted environment. Please check the conditions in following checking for procedure to improve about 'Water leak Issue'. [From when did this problem start?] [1: Immeadiately after purchase.] [2: During normal operation] [3: After physical movement] [4: After the previous repair/maintenance service] Customers also found this information helpful. There is something wrong with Air-conditioner. What should I do? How do I check & clean the indoor unit air filter? Procedure for Drain Hose placement. Do we need to service the Condensing (outdoors) unit? If, yes, how often? Why does ice-forms on the copper pipes of the condenser (outdoor) unit?

Sometimes you may notice that your air conditioner freezes up after some time of operation. When this happens, the cool air will not be discharged properly and eventually a huge block of ice may built up on the evaporator coil. You will notice that there is less airflow coming from the air ventilation as ice began to clog the air movement. More condensation can be seen at the drain pan. At the same time, the room is no longer cool. This means that it is time to investigate the causes of this problem. Here are some possible causes. When air flow or air circulation from the unit to the room and vice versa is restricted, the exhange of thermal energy between the air conditioner and the room is restricted. As a result, most of the cool air continues to stay around the evaporator coil and fins causing the temperature around them to drop. As a result, ice is formed and gradually more ice began to built up and eventually causes the air conditioner freezes up. Air Filters at the return air of the equipment must be serviced regularly by taking them down and wash with water and soap.

These filters are used to trap dust and other bigger contaminants from going into the evaporator fins. Hence, cleaning them at least one or twice a month is highly recommended. ac unit for starcraft pop upIn many cases, users will not even clean them once a year until this problem begin to surface.super nano air handling unitEvaporator coil and fins that are located after the air filters can also be clogged up due to dirty filters. car air conditioning repair northamptonIn this case, you will need to clean them by using a spray type coil cleaner. The other alternative is to get the technicians to come and take down the entire evaporator for cleaning. This will be more costly. Therefore, regular maintenance of the evaporator coil and air filters will go a long way in ensuring that your air conditioner continues to function properly.

Fan or blower at the evaporator unit may not be functioning. When the unit is on, check that there is air flow coming out of the equipment. Otherwise, the fan may be damaged. In this case, the fan motor may have burnt or some loose connections may have occurred. Get a technician to check if this is the case.Check that there is no blockage of air around the evaporator by ensuring that things are not placed too near to the evaporator.One other step you can do is to check the set temperature of the air conditioner. Make sure that it is not set lower than 70 °F. When the refrigerant in the system is low due to leakage over time, there will be a decrease in the saturation point temperature of the system. When this happens, it will take a lower temperature for all the refrigerant liquid that has been compressed by the compressor to become vapor in the evaporator. This means that the operating temperature of the cooling coils has now dropped compared to the original design. This lower temperature will cause moisture collected from the air to quickly becomes ice on the evaporator when the temperature goes below below 32 °F.

These moisture that is supposed be cooled to a level which becomes water and drips to the condensate drainage pan is now stuck at the evaporator coils and fins forming ice around them. When this continues on, eventually a block of ice is formed on it. When you see the ice being formed on the evaporator, off the unit and wait for the ice to melt. It could take a few hours for all the ice to melt. A faster way is to on the air conditioner but using Fan mode. That means, only the fan is operating but the compressor is off. This will reduce the melting time of the ice but you will need to be around to monitor it as water may overflow and cause damage to your furniture or electrical items.A low refrigerant problem can only be solved by a qualified HVAC technician as additional refrigerant will have to be added to the system. Another possible cause is when you are operating your air conditioner when the outdoor temperature outside the house is low. When this happens, try to run the air conditioner using fan mode or simply use the outside air to ventilate your room.

Back To Air Conditioner Freezes Up Home pageThe FS Multi is a variable refrigerant flow (VRF) system that uses a single outdoor unit to independently control multiple indoor units. By communicating with the indoor units the outdoor unit controls the flow of refrigerant to each one of them to matchMaximum combination of indoor unit:8The Panasonic U 10EA1E8 7.9 Ton AC employs the VRF air conditioning system that bestows full control to one single unit placed outdoor to control numerous indoor units placed outside. With a refrigerant free system, it saves you the trouble of calculations for charging it and avoids shortage of cooling capacity.The capacity of the Panasonic AC with VRF system is 7.9 ton, which makes it ideal for office buildings, shopping malls and residential complexes. This white colored multi-split air conditioner comes with the dimension of 1745 X 920 X 760 mm and the total weight of the unit is 210 KG.The built-in air filters removes the dust and the allergens from the air.

Single outdoor unit of this AC controls multiple indoor units individually. It has flexible controls like selection for heating and cooling, power safe mode, silent mode for outdoor unit, auto restart, forced stop input etc.This Ac can cool or warm the rooms with specific temperature and maintain it while saving lot of energy. This equipment is used for cooling as well as heating the rooms as it has a hyper wave inverter.This is the economic way of enjoying the coolness in the rooms.The sound pressure is 59 dB(A) and noise level is 79 dB.It employs Hyper wave technology to bestow maximum torque from the compressor. Variable Refrigerant Flow technology is used in this multi-split air conditioner. This cooling system uses only one outdoor for managing and controlling the indoor units, independently. The inverter converter control provides energy saving operations. The refrigerant type is R410A/11Kgs. The cooling capacity is 28.00 (95,600) KW (Btu/hour) for this air conditioner. The power input is 8310 Watts for this cooling machine.